Forum Index > General > Where the heck do you get a ....
 Quick PCB prototyping
 |  Printable Version
By: Pneumatic (offline) on Friday, October 30 2009 @ 01:32 PM PDT (Read 2249 times)  

I'm looking for a few days turnaround, and making ~100 PCBs.
Where can I go for quick PCB prototyping?
Would I be better off setting up my own wet-etch system for protos? Toner transfer method or photoresist? (I haven't done a wet-etch since high-school, about 20 years ago.)

-- Mitch

Forum Apprentice

Status: offline

Registered: 10/05/09
Posts: 1

Profile Email    
By: Windell (offline) on Friday, October 30 2009 @ 01:57 PM PDT  

Eek. That's a tough spot to be in. 2-3 in a couple days is easy. 100 in a couple weeks is easy. 100 in a couple days usually gets expensive. My usual go-to services are pcbexpress (from sunstone) and pcbfabexpress. Not sure how either will do with those params. Who is the best will depend on what specs you need as well-- with soldermask & silkscreen, it's not so easy to do at home.

Windell H. Oskay

Forum Evil Scientist
Evil Scientist

Status: offline

Registered: 06/15/06
Posts: 1932
Sunnyvale, CA

Profile Email Website  

 All times are PDT. The time is now 08:00 PM.
Normal Topic Normal Topic
Locked Topic Locked Topic
Sticky Topic Sticky Topic
New Post New Post
Sticky Topic W/ New Post Sticky Topic W/ New Post
Locked Topic W/ New Post Locked Topic W/ New Post
View Anonymous Posts 
Able to Post 
Filtered HTML Allowed 
Censored Content 

Evil Mad Scientist Forum Archives — Read only!

Please visit our new forums for new discussions.

DIY Hardware for Electronic Art

The Original Egg-Bot Kit

Interactive LED kits

Meggy Jr RGB
LED matrix game
development kit.

Business-card sized
AVR target boards

Peggy 2
LED Pegboard kits

My Account

Lost your password?