Forum Index > Projects > Micro-readerboard project support
 |  Printable Version
By: Anonymous: xDGx () on Tuesday, July 27 2010 @ 04:41 AM PDT (Read 4054 times)  
Anonymous: xDGx

Hello. I've assembled a Diavolino and powered it up with the USB-TTL cable. After that I've uploaded a sketch to it and it worked fine. Everytime I try to upload a second sketch to the board, it fails, getting this:

avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51

Then, to upload the new sketch I have to disconnect the cable from the PC, plug it again, and then re-upload sketch.
Is that normal behaviour ?

Thank you

By: Windell (offline) on Tuesday, July 27 2010 @ 10:19 AM PDT  

This happens on Windows machines.

Try adjusting your port settings to end the pain: Device Manager - Comm Ports - USB Serial Port - Port Settings - Advanced button - Set RTS On Close.

Windell H. Oskay

Forum Evil Scientist
Evil Scientist

Status: offline

Registered: 06/15/06
Posts: 1932
Sunnyvale, CA

Profile Email Website  

 All times are PDT. The time is now 06:52 AM.
Normal Topic Normal Topic
Locked Topic Locked Topic
Sticky Topic Sticky Topic
New Post New Post
Sticky Topic W/ New Post Sticky Topic W/ New Post
Locked Topic W/ New Post Locked Topic W/ New Post
View Anonymous Posts 
Able to Post 
Filtered HTML Allowed 
Censored Content 

Evil Mad Scientist Forum Archives — Read only!

Please visit our new forums for new discussions.

DIY Hardware for Electronic Art

The Original Egg-Bot Kit

Interactive LED kits

Meggy Jr RGB
LED matrix game
development kit.

Business-card sized
AVR target boards

Peggy 2
LED Pegboard kits

My Account

Lost your password?