Forum Index > Projects > Diavolino
 Diavolino Uploading issues
 |  Printable Version
By: Anonymous: dargs () on Wednesday, August 18 2010 @ 06:22 AM PDT (Read 3635 times)  
Anonymous: dargs

Just to add this easy problem to fix into this forum also for others to find...

When having issues uploading sketches to Diavolino using FTDI cables and windows, would work the first time then fail until the board is power-cycled.

squall_line said:
Try adjusting your port settings to end the pain: Device Manager - Comm Ports - USB Serial Port - Port Settings - Advanced button - Set RTS On Close.

As per http://www.evilmadscientist.com/forum/viewtopic.php?showtopic=3270


I found this fixed my problem straight away.

Thanks squall_line and Windell !





       
   
By: Windell (offline) on Wednesday, August 18 2010 @ 09:50 AM PDT  
Windell

Thanks dargs,
appreciate it!


Windell H. Oskay
drwho(at)evilmadscientist.com
http://www.evilmadscientist.com/

Forum Evil Scientist
Evil Scientist

Status: offline

Registered: 06/15/06
Posts: 1932
Sunnyvale, CA

Profile Email Website  
   
By: Anonymous: Alex T () on Thursday, May 05 2011 @ 10:46 AM PDT  
Anonymous: Alex T

I'm having the same problem on my Macbook, however it's a bit worse as I can't seem to upload anything after the initial "blink" sketch to test it. I've tried unplugging everything yet I still receive the error msg:

avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x00

Any thoughts for a Mac user?





       
   
By: atatistcheff (offline) on Thursday, May 05 2011 @ 10:58 AM PDT  
atatistcheff

I just signed up for an account so I'm replying to my own post to say that I figured out the problem. I didn't clean the flux off the bottom of the board after soldering. After doing that the programming works fine - ya rookie mistake.

Alex


Forum Apprentice
Apprentice

Status: offline

Registered: 05/05/11
Posts: 1

Profile Email    
   



 All times are PDT. The time is now 10:55 PM.
Normal Topic Normal Topic
Locked Topic Locked Topic
Sticky Topic Sticky Topic
New Post New Post
Sticky Topic W/ New Post Sticky Topic W/ New Post
Locked Topic W/ New Post Locked Topic W/ New Post
View Anonymous Posts 
Able to Post 
Filtered HTML Allowed 
Censored Content 

Evil Mad Scientist Forum Archives — Read only!

Please visit our new forums for new discussions.


DIY Hardware for Electronic Art


The Original Egg-Bot Kit


Octolively
Interactive LED kits


Meggy Jr RGB
LED matrix game
development kit.


Business-card sized
AVR target boards


Peggy 2
LED Pegboard kits

My Account






Lost your password?