Forum Index > Projects > Diavolino
 Diavolino Uploading issues
 |  Printable Version
By: Anonymous: dargs () on Wednesday, August 18 2010 @ 06:22 AM PDT (Read 3665 times)  
Anonymous: dargs

Just to add this easy problem to fix into this forum also for others to find...

When having issues uploading sketches to Diavolino using FTDI cables and windows, would work the first time then fail until the board is power-cycled.

squall_line said:
Try adjusting your port settings to end the pain: Device Manager - Comm Ports - USB Serial Port - Port Settings - Advanced button - Set RTS On Close.

As per

I found this fixed my problem straight away.

Thanks squall_line and Windell !

By: Windell (offline) on Wednesday, August 18 2010 @ 09:50 AM PDT  

Thanks dargs,
appreciate it!

Windell H. Oskay

Forum Evil Scientist
Evil Scientist

Status: offline

Registered: 06/15/06
Posts: 1932
Sunnyvale, CA

Profile Email Website  
By: Anonymous: Alex T () on Thursday, May 05 2011 @ 10:46 AM PDT  
Anonymous: Alex T

I'm having the same problem on my Macbook, however it's a bit worse as I can't seem to upload anything after the initial "blink" sketch to test it. I've tried unplugging everything yet I still receive the error msg:

avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x00

Any thoughts for a Mac user?

By: atatistcheff (offline) on Thursday, May 05 2011 @ 10:58 AM PDT  

I just signed up for an account so I'm replying to my own post to say that I figured out the problem. I didn't clean the flux off the bottom of the board after soldering. After doing that the programming works fine - ya rookie mistake.


Forum Apprentice

Status: offline

Registered: 05/05/11
Posts: 1

Profile Email    

 All times are PDT. The time is now 01:25 PM.
Normal Topic Normal Topic
Locked Topic Locked Topic
Sticky Topic Sticky Topic
New Post New Post
Sticky Topic W/ New Post Sticky Topic W/ New Post
Locked Topic W/ New Post Locked Topic W/ New Post
View Anonymous Posts 
Able to Post 
Filtered HTML Allowed 
Censored Content 

Evil Mad Scientist Forum Archives — Read only!

Please visit our new forums for new discussions.

DIY Hardware for Electronic Art

The Original Egg-Bot Kit

Interactive LED kits

Meggy Jr RGB
LED matrix game
development kit.

Business-card sized
AVR target boards

Peggy 2
LED Pegboard kits

My Account

Lost your password?