Forum Index > Projects > Diavolino
 Zero Ohm Jumpers
 |  Printable Version
By: Anonymous: Twmaster () on Saturday, February 05 2011 @ 06:01 PM PST (Read 2104 times)  
Anonymous: Twmaster

Got a question for the lead Evil Mad Scientists...

Received my Little Devil today, thank you. Nice kit.

For now I am powering it off the USB bus. I've installed the zero ohm jumper from the FTDI header.

I am not using a regulator. Here's where the instructions seem a tad murky to me...

Do I also need a jumper in the position marked as no regulator? I'm curious as I have powered the board up and uploaded a sketch and all seems to be fine.

Thanks.

Mike N
Junior Evil (only slightly miffed) Scientist.






       
   
By: Anonymous: Twmaster () on Saturday, February 05 2011 @ 06:10 PM PST  
Anonymous: Twmaster

Gah. Nevermind....

I found the answer. I should have read *all* of the other posts.

Sorry for the noise.

--
Mike N
Junior Evil Maddeningly Moronic Scientist.





       
   



 All times are PDT. The time is now 04:31 PM.
Normal Topic Normal Topic
Locked Topic Locked Topic
Sticky Topic Sticky Topic
New Post New Post
Sticky Topic W/ New Post Sticky Topic W/ New Post
Locked Topic W/ New Post Locked Topic W/ New Post
View Anonymous Posts 
Able to Post 
Filtered HTML Allowed 
Censored Content 

Evil Mad Scientist Forum Archives — Read only!

Please visit our new forums for new discussions.


DIY Hardware for Electronic Art


The Original Egg-Bot Kit


Octolively
Interactive LED kits


Meggy Jr RGB
LED matrix game
development kit.


Business-card sized
AVR target boards


Peggy 2
LED Pegboard kits

My Account






Lost your password?