Hi,

I am a very beginner in Peggy, Arduino and Flex.

I am using the example from (http://www.leonardsouza.com/flex/flash-to-peggy/)

Yes, I am able to solve all the software problems (i guess...).Unless no compile error.

My problem is, i compile the "arduino_serial_proxy" without error and my Peggy 2.3 have signal.
But when I compile the Flex project, my Peggy 2.3 have not response on it. And my Flex project (the visualizer shop to render to animation too).

I wonder if my hardware config has problem or not. Please look at my images below.

http://soimperfect.com/peggy23_hardware.jpg


I think i am in Serial mode, right?

I don't know what flex is, nor about the rest of your setup, but there's definitely a problem on your board. You need to pick EITHER the P2 or SER option, NOT both. It may damage your hardware to operate this way.

Now, if you're trying to use Leonard's example directly, with an external Arduino, you should be in P2 mode. If you are going to talk directly from your computer to the Peggy over the serial port, you should be in SER mode.