I am attempting to program an attiny2313 and i finally got the damn Arduino as ISP right, and finally got the steps right for applying 0 then 30-5.5v on the attiny2313 then programming within the next 300 microseconds.
Whenever i run the try programming the attiny2313, avrdude runs and completes its program and whatnot, but then it said "verification error: mismatch on 0x00000" and some other things. I think this means that it did not correctly write to the flash on the attiny2313.

i used the correct code to write to the Arduino, with the programmer as: avrsip; the device as: attiny2313; port as: com3; and writing: flash:w:larsonextend.hex

http://arduino.cc/forum/index.php/topic,64149.new.html#new

I am attempting to program an attiny2313 and i finally got the damn Arduino as ISP right, and finally got the steps right for applying 0 then 30-5.5v on the attiny2313 then programming within the next 300 microseconds.

Are you using the ISP Shield? It sounds like you're still having significant issues with your ISP setup-- not sure this falls under Larson Scanner support....

folsompoint --

This problem you describe sounds very similar to one I'm having. Did you ever get a resolution?

Thanks in advance.

--Karl B.

Never mind -- found the issue in my circuit. In this case, faulty soldering.

--Karl B.