Forum Index > Projects > LED Pegboard and Matrix Projects
 Power Supply substitution
 |  Printable Version
By: Anonymous: Tina () on Wednesday, April 25 2012 @ 12:06 PM PDT (Read 710 times)  
Anonymous: Tina

I just ordered the Peggy 2, and I was sent a power supply with a 2.1 x 5.5 mm barrel with the appropriate jack. I am not sure if I am supposed to solder this to the board at location J2 where the power jack is located. Can anyone clarify this. I was instead sent what looks like a three prong adapter?



Tina






       
   
By: Windell (offline) on Wednesday, April 25 2012 @ 12:57 PM PDT  
Windell

The power jack should be soldered to the board, the power supply should not. The jack has three pins, that fit into the three holes on the board.


Windell H. Oskay
drwho(at)evilmadscientist.com
http://www.evilmadscientist.com/

Forum Evil Scientist
Evil Scientist

Status: offline

Registered: 06/15/06
Posts: 1932
Sunnyvale, CA

Profile Email Website  
   
By: Anonymous: Tina () on Thursday, April 26 2012 @ 05:56 AM PDT  
Anonymous: Tina

Thanks, I figured as much, but I always like to double check!







       
   



 All times are PDT. The time is now 01:51 PM.
Normal Topic Normal Topic
Locked Topic Locked Topic
Sticky Topic Sticky Topic
New Post New Post
Sticky Topic W/ New Post Sticky Topic W/ New Post
Locked Topic W/ New Post Locked Topic W/ New Post
View Anonymous Posts 
Able to Post 
Filtered HTML Allowed 
Censored Content 

Evil Mad Scientist Forum Archives — Read only!

Please visit our new forums for new discussions.


DIY Hardware for Electronic Art


The Original Egg-Bot Kit


Octolively
Interactive LED kits


Meggy Jr RGB
LED matrix game
development kit.


Business-card sized
AVR target boards


Peggy 2
LED Pegboard kits

My Account






Lost your password?