 |
By: Anonymous: Tina () on Wednesday, April 25 2012 @ 12:06 PM PDT (Read 509 times)
|
|
|
Anonymous: Tina |
| Anonymous: Tina |
|
I just ordered the Peggy 2, and I was sent a power supply with a 2.1 x 5.5 mm barrel with the appropriate jack. I am not sure if I am supposed to solder this to the board at location J2 where the power jack is located. Can anyone clarify this. I was instead sent what looks like a three prong adapter?
Tina
|
|
|
|
|
|
|
By: Windell (offline) on Wednesday, April 25 2012 @ 12:57 PM PDT
|
|
|
Windell |
| Windell |
|
The power jack should be soldered to the board, the power supply should not. The jack has three pins, that fit into the three holes on the board.
Windell H. Oskay
drwho(at)evilmadscientist.com
http://www.evilmadscientist.com/
|
Evil Scientist
 Status: offline
Registered: 06/15/06
Posts: 1932
Sunnyvale, CA
|
|
|
|
|
|
By: Anonymous: Tina () on Thursday, April 26 2012 @ 05:56 AM PDT
|
|
|
Anonymous: Tina |
| Anonymous: Tina |
|
Thanks, I figured as much, but I always like to double check!
|
|
|
|
|
|
Power Supply substitution
