Forum Index > Projects > Egg-Bot
 Servo does not respond
 |  Printable Version
By: Anonymous: Gordon Nezich () on Tuesday, May 15 2012 @ 12:37 AM PDT (Read 1204 times)  
Anonymous: Gordon Nezich

Hi,
My Eggbot worked fine till recently, now the servo arm does not respond to any commands, either from Inkscape or the Eggbot control.
Thinking it was the servo, I bought a new expensive servo, installed it, and it also does not respond to any commands.
The Eggbot goes through it's drawing program correctly except the servo does nothing.
Yes, it's plugged in correctly.
Could this be a faulty board? I can't see any obvious problems with the board visually.
Thanks
Gordon





       
   
By: Lenore (offline) on Tuesday, May 15 2012 @ 12:31 PM PDT  
Lenore

Hi Gordon,
I've responded to your email message with some additional questions to try and narrow down the problem.
Lenore


Forum Scientist
Scientist

Status: offline

Registered: 06/15/06
Posts: 55
Sunnyvale, CA

Profile Email Website  
   



 All times are PDT. The time is now 04:07 AM.
Normal Topic Normal Topic
Locked Topic Locked Topic
Sticky Topic Sticky Topic
New Post New Post
Sticky Topic W/ New Post Sticky Topic W/ New Post
Locked Topic W/ New Post Locked Topic W/ New Post
View Anonymous Posts 
Able to Post 
Filtered HTML Allowed 
Censored Content 

Evil Mad Scientist Forum Archives — Read only!

Please visit our new forums for new discussions.


DIY Hardware for Electronic Art


The Original Egg-Bot Kit


Octolively
Interactive LED kits


Meggy Jr RGB
LED matrix game
development kit.


Business-card sized
AVR target boards


Peggy 2
LED Pegboard kits

My Account






Lost your password?