Forum Index > General > Ask an Evil Mad Scientist!
 10 pin AVR programmer?
 |  Printable Version
By: Anonymous: soldersucker () on Tuesday, June 19 2007 @ 03:20 PM PDT (Read 3433 times)  
Anonymous: soldersucker


I know the USBtinyISP programmer from Adafruit has both a 6 and 10 pin cable, but what other programmers out there have 10 pin cables? The Atmel AVRISP Mk2 appears to only have a 6 pin one.

I'm asking because it's difficult for my company to order from anyone besides approved vendors. Digikey and all the big places are approved, however I can't find what I'm looking for.





       
   
By: Windell (offline) on Tuesday, June 19 2007 @ 04:04 PM PDT  
Windell

You should be able to wire up an adapter cable with $3 worth of parts from Digi-Key in about five minutes-- all of the signals on the 10-pin connector are on the 6-pin connector as well.

Secondly, I *believe* that the Atmel AVRISP Mk2 does secretly have a 10-pin connector. There is an unpopulated 10-pin socket footprint on the circuit board. At least in the AVRISP MkI, these two connectors were wired in parallel, so it stands to reason that they are the same and you could just add your own 10-pin header and ribbon cable. However, I haven't actually tried it yet so I can't promise that it works.

Finally, there is still the old STK500 (Digi-Key part ATSTK500-ND, $84), which does have a 10-pin ISP connector... but it's expensive and requires a "real" serial port.


Windell H. Oskay
drwho(at)evilmadscientist.com
http://www.evilmadscientist.com/

Forum Evil Scientist
Evil Scientist

Status: offline

Registered: 06/15/06
Posts: 1932
Sunnyvale, CA

Profile Email Website  
   
By: Anonymous: errantengineer () on Wednesday, July 04 2007 @ 07:16 AM PDT  
Anonymous: errantengineer

While the Atmel STK500 does need a serial port, it doesn't need a REAL serial port, you can use a USB->serial adapter cable.

Cheaper than the STK500 is the AVRISP which has 6pin and 10pin provision.

This board: http://matwei.de/doku.php?id=en:electronics:usbisp is also good. I bought 2 PCBs fomr him and built them up, nice little USB based STK500 compatible programmer.





       
   



 All times are PDT. The time is now 06:08 PM.
Normal Topic Normal Topic
Locked Topic Locked Topic
Sticky Topic Sticky Topic
New Post New Post
Sticky Topic W/ New Post Sticky Topic W/ New Post
Locked Topic W/ New Post Locked Topic W/ New Post
View Anonymous Posts 
Able to Post 
Filtered HTML Allowed 
Censored Content 

Evil Mad Scientist Forum Archives — Read only!

Please visit our new forums for new discussions.


DIY Hardware for Electronic Art


The Original Egg-Bot Kit


Octolively
Interactive LED kits


Meggy Jr RGB
LED matrix game
development kit.


Business-card sized
AVR target boards


Peggy 2
LED Pegboard kits

My Account






Lost your password?